Bucephalandra Motleyana Red Under Leaf

Underwater appearance

This small to medium trade form usually has elongated to oval leaves. Its typical colour is described as green upper surfaces with reddish colouring most noticeable beneath the leaf or on new growth. Leaf form and colour can change with the specimen, leaf age, lighting, nutrients, CO₂, and viewing angle.

It grows from a creeping rhizome, which is the firm horizontal stem that produces roots and leaves. It attaches to rock or wood and slowly develops a compact colony rather than a fast carpet.

It is normally used for raised hardscape where the coloured leaf undersides can be seen. During the first few weeks, expect adjustment and root development rather than rapid spread. A firm growing point, intact roots, or one new leaf can be a better early sign than visible size increase.

Essentials

• Start with low to medium light.
• Attach it to rock or wood. Roots may reach the substrate, but the rhizome must remain exposed.
• Provide gentle to moderate circulation so debris does not remain on the leaves.
• Keep temperature and water chemistry reasonably stable.
• Use a complete aquarium fertiliser when the tank does not already provide enough nutrients.
• A mature aquarium is helpful but not mandatory. Stability matters more than a particular tank age.

Optional improvements

• Stable injected CO₂ may improve submerged growth and recovery.
• Moderate light can improve colour, but excessive light raises algae pressure on slow leaves.
• Placing roots near nutrient-containing substrate may help some specimens, provided the rhizome or crown remains exposed.

Beginner setup checklist

• Stable, filtered freshwater setup
• Low or moderate light
• Secure rock or wood attachment point
• Gentle water movement around the leaves
• Consistent, restrained fertilising
• No buried rhizome or crown
• It is generally suitable for a patient beginner.

CO₂ level

Injected CO₂ is optional. The plant can grow without injection in a stable low-tech aquarium, although growth is usually slow.

Stable CO₂ can improve recovery, growth speed, leaf density, and the visibility of colour or iridescence. It cannot guarantee a particular colour or leaf size, and this plant will still grow more slowly than most stem plants.

Keep CO₂ steady and balance it with moderate light, complete nutrition, and good circulation. Unstable CO₂ combined with strong light can increase algae and adjustment problems.

Preparation

• Inspect the plant and remove fully soft, broken, or decayed tissue with clean scissors.
• If supplied in a pot or rock wool, remove the container and clean away as much wool as possible without tearing healthy roots.
• Rinse in clean aquarium-safe water and inspect for algae, snails, or damaged roots.
• Do not divide a weak or very small plant merely to create more portions.

Positioning

• Place the plant on rock or wood with the horizontal rhizome visible above the surface.
• Roots may touch or enter gravel, but do not bury the rhizome.
• Leave open space around the leaves for water movement and future growth.

Tissue-culture portions

• Rinse away all culture gel before placement.
• Separate only into natural clumps with roots and a growing point.
• Secure each clump gently and avoid crushing the rhizome or crown.

Attachment methods

This is an epiphytic rhizome plant and is normally attached to wood or stone.

• Thread: tie the plant loosely with cotton thread until the roots grip the surface.
• Fishing line: use a loose transparent wrap and check that it does not cut into growing tissue.
• Cyanoacrylate super glue gel: use one or two tiny drops on a root or the underside of the rhizome. Do not coat the whole rhizome.
• Mesh: use gentle mesh only for small portions, without crushing leaves, roots, rhizome, or crown.

Choose a surface with some water movement and avoid deep burial.

Routine trimming

Use clean, sharp aquascaping scissors. Slow-growing rheophytic aroids usually need little routine trimming.

• Cut a fully damaged or decaying leaf stalk close to the base without cutting the rhizome or crown.
• Do not remove a large share of healthy leaves at one time.
• To reduce a mature clump, cut between healthy rhizome sections only when each section has leaves and preferably roots.
• Leaf-only trimmings cannot normally be replanted. A useful cutting needs a growing point or healthy rhizome section.

Selective trimming keeps the plant tidy. Heavy cutting reduces density and can slow recovery for many weeks.

Rhizome division

• Wait until the plant has more than one healthy growing section.
• Choose a section with several leaves and, where possible, its own roots.
• Use clean scissors or a blade to make one clean cut through the rhizome.
• Attach the new section to rock or wood with the rhizome exposed.
• Keep light, CO₂, nutrients, and water conditions stable during recovery.

The new plant is ready to separate when it has enough leaves and roots to remain stable on its own.

Normal adjustment

Slow establishment is normal. Transported or emersed-grown leaves may weaken while the plant produces growth suited to its new conditions.

Limited loss of older leaves can be acceptable when the rhizome or crown remains firm and new roots or leaves eventually appear.

What to monitor

• Normal: firm growing tissue, intact roots, slow new growth, and limited older-leaf loss.
• Needs attention: a soft or darkening rhizome, spreading decay, repeated loss of new leaves, or heavy algae and debris coating the foliage.
• Review recent changes in light, CO₂, fertiliser, temperature, flow, and water chemistry before changing another factor.

The word Motleyana in this trade name does not by itself confirm the botanical species identity.